TEL AFA4000/2, Инструкция по установке и эксплуатации

Страница: 95 / 177

AFA4000/2 Airflow Monitor / p.95
‘ Display Smoothing ’ parameter in the cal config menu. The monitor will display the
velocity value as a rolling average over time and is adjustable over 1 to 100 seconds.
•
Do not use fully open and fully closed sash positions for the calibration points. The
recommended positions are normal operating height (for example,
500 mm 20”) for
the first sample and approximately half the sash opening (for example, 250 mm 10”)
for the second sample. Do not close the sash below 150mm.
7.2 Auto Sash Controller 1, 2 or 3 position.
This section describes the calibration of the Auto Sash Controller from the
AFA4000/2/AS.
Note: Refer to section 7.4 to calibrate the Auto Sash Controller from the Auto Sash keypad
1. From the Run Screen press and hold the Mute button for 5 seconds until the Main
Menu is displayed.
2. Use the
↑
/
↓
buttons to select Set Up Auto Sash . The display shows the message TEL
SASH CLOSER .
3. Press the Mute button to display the current Hardware and Software version, for
example, 1. HW2.0 FW1.1 .
4. Press the
↓
button to scroll down and select Setup Menu and press Mute .
5. Enter the password (the factory default password is 1-0-0-1) and press Mute to
continue.
6. In the Setup menu the controller displays System Profile .
7. Use the
↓
button to scroll through the menu, select Sash 1 Settings and press Mute .
8. In the S1 Settings menu , the display will show 1. Enabled .
9. Use the ↓ button to scroll through the menu and select 8. Calibration and press Mute .
10. Follow the on-screen instructions and set the sash to the centre opening, for example,
250 mm.
11. Press the
↓
button to find which arrow represents the sash closing and press Mute .
This step shows the controller which direction the motor needs to drive to close the
sash.
12. Close the sash and press Mute . This step sets the sash position sensor output, 0 V
position.