TEL AFA4000/2, Инструкция по установке и эксплуатации

Страница: 101 / 177

AFA4000/2 Airflow Monitor / p.101
6. Press
↓
button, select 11. Auto Lock and press Enter .
7. Set to Enabled and press Enter .
8. Press
↓
button, select 11b. Lock Alarm and press Enter .
9. Press
↑/↓
buttons to set the required alarm delay time and press Enter .
10. Press
↓
button, select 11c. Lock Pos Calibration and press Enter .
Instructions will be displayed, for example: Lock the sash then move the sash to the
lowest lock position. Enter to accept. Cancel to abort
11. Open the sash to the Lock position and press Enter .
If the position chosen is too low, lower than the calibrated Bottom, Middle or Top
positions,
Bad position - try again will be displayed.
If the chosen position is acceptable, the lock position will be set.
12. Press
↓
button, select Back to Set up menu and press Enter .
13. Press
↓
button, select Exit and Save Changes and press Enter .
The Auto Sash Controller will now go to RUN mode.
7.4.4 Calibrating the safety light curtain
To adjust the range and sensitivity of the Safety Light Curtain:
1. Ensure the area between the Safety Light Curtain transmitter and receiver is free from
obstructions.
2. Ensure the light beam paths are not broken and the Personnel Sensor is disabled so
that the sash does not Auto-Close whilst the Safety Light Curtain is being calibrated.
Note: If it is not possible to disable the Personnel Sensor, remove the motor / clutch
connector from the Auto Sash Control Unit. This activates the Sash Control
Alarm after the selected time delay and the reset button must be pressed once
the Safety Light Curtain has been calibrated.
3. Remove the cover from the Safety Light Curtain Control Box.