Tecnoalarm TP16-256, Руководство по установке

Страница: 201 / 248

TP16-256 - Installer Manual Control by Keypoint
7-5
CHECK SYSTEM STATUS
Prior to arming of the control panel, always check system status with the help of
yellow OCG LED:
z
LED blinking = general alarm (e.g. low battery, power failure,
tamper) active or system armed (i.e. one of the 32
programs is armed) and program alarm active
z
LED on = alarm memory
CHECK PROGRAM LED STATUS
The 3 LED (green, yellow, red) indicate the status of the 3 programs associated:
z
LED on = program armed
z
LED off = program disarmed
z
LED blinking quickly
(2 flashes per second)
= exit time, arming phase or warning of end of by-pass
active
z
LED blinking slowly
(1 flash per second)
= program partset or not OK during the arming phase
7.2.1.1 SINGLE ARMING
Introduce the electronic key into the key reader.
The LED of the first program associated to the key blinks quickly for 3 seconds.
After 3 seconds, the LED corresponding to the program selected starts blinking slowly
and the 10-seconds zone exclusion time is started.
Remove the key from the key reader.
ZONE EXCLUSION TIME
For 10 seconds after selecting the program, it is possible to exclude manually the
open zones with a procedure explained lateron.
If you do not wish to exclude any zone, it is however possible to select another
program deselecting the one you have only just selected by introducing the key into
the key reader again.
WARNING
The interface for electronic keys permits to control merely 3 of the 32 programs through the key
readers connected. Program status is signaled by the LED on the key readers.
The 3 program LED are by default associated to the first 3 programs of the control panel. The
installer can associate the LED of every single key reader to any of the 32 programs.
WARNING
If the key is removed and reintroduced within 3 seconds the next program is selected etc. until
selecting the third program after which the key reader returns to stand-by.
This valid only if the first 3 programs of the control panel are associated to the key. The programs not
associated are not viewed nor activated.
WARNING
On arming of a program in presence of open zones, the alarm devices programmed (sirens/logic
outputs/telephone channels) are activated unless the open zones are exluded with a procedure
explained lateron.