Tecnoalarm TP16-256, Руководство по установке

Страница: 190 / 248

Control by Console Installer Manual - TP16-256
6-10
WARNING
Disarming by hold-up code (disarming under duress) causes no signaling by the console. The event
is stored in the event buffer.
If the user code ends on 0, e.g. 43670, the hold-up code ends on 9, in this case 43679.
WARNING
Outside the access periods associated the codes are not accepted by the control and any attempt at
acceding to the system will have no effect.
When trying to do so, on the display is viewed
ACCESS ! DENIED ! .
6.2.2 DISARMING WITH STANDARD USER CODE
Whereas the master code is always enabled for all the programs, the standard user
codes merely control the programs the have been enabled for by the installer or the
holder of the master code.
Enter a user code appropriately programmed, e.g. standard user code number 1:
+
11111
For the 10 seconds to come, it is possible to select the programs to be armed/
disarmed (pressing the program number once the program is selected, pressing it
again the program is deselected).
On every keystroke the counter is reset.
Select the programs to be disarmed, e.g.:
+
1 2
Procede as for disarming with master code (see § 6.2.1).
6.2.2.1 TOTAL DISARMING
See § 6.2.1.1.
6.2.3 DISARMING UNDER DURESS (IF ENABLED)
In case of robbery, it is possible to simulate disarming of the system and release
simultaneously a hold-up alarm.
For this enter the master code or a standard user code (enabled for the programs
armed) reducing the last digit by one unit, e.g. master code (default code 12345):
+
12344
The control panel is apparently disarmed, i.e. all the program LED are switched off,
and if programmed appropriately by the installer, the logic outputs OUT1 or OUT2 of
the CPU board and all the modules connected and a telephone call for hold-up alarm
are activated.
6.2.4 QUICK DISARMING (IF ENABLED)
It is possible to speed up the disarming process by pressing the key * (star) followed
by the program number, e.g.:
+
*1
+
*2
Repeat the command for all the programs to be disarmed.
6.2.5 DISARMING THROUGH KEY ZONE
The control panel can be disarmed through a contact connected to a zone
programmed by the installer as key zone.
Every time the contact is opened, all the programs that contain the key zone are
disarmed.
6.2.6 AUTOMATIC DISARMING
The control panel can be disarmed automatically using the 32 timers. Therefore, it is
possible to schedule disarming with a determined frequency and at a determined time
acting on determined programs.
At the time programmed the timer disarms the programs associated.
6.2.7 DISARMING DURING THE ACCESS PERIODS
It is possible to define up to 8 access periods of the codes. As a consequence, the
codes are enabled for arming and disarming during the access periods associated by
the installer or the holder of the master code only.
- ACCESS -
User 001