Tecnoalarm TP16-256, Руководство по установке

Страница: 178 / 248

Programming by Console Installer Manual - TP16-256
5-38
S1 S2 S3 S4
Yes Yes --- ---
MENU
19 19
19 19 19
Menu 19
Test
Radio 2
Monit.M1 RF868
Radio 3
Monit.M2 RF433
Radio 4
Monit.M2 RF868
Test 1
Radio
Radio 1
Monit.M1 RF433
Monit.M1 RF433 1
Level = -95dBm
Radio 5
Reception
Reception
TX110 Zone 025
Radio 6
Con. sirens
Con. sirens
Waiting
5.22 TEST
+
yw
to select the menu (19)
+
#
YES to confirm the selection
Submenus
z
Radio Functioning test of the wireless section
z
Zones Functioning test of the zones
z
Indoor siren Functioning test of the indoor siren
z
Outdoor siren Functioning test of the outdoor siren
z
Version Viewing of the firmware version of the control panel
z
Vocal synthesis Viewing of the vocabulary version of the control panel
z
LED console Viewing of the LED status of the console
z
GSM Viewing of the status of the GSM telephone communicator
Commands available
+ yw
to select the parameter
+
#
YES to confirm the selection
5.22.1 WIRELESS SECTION TEST
Submenus
z
Monit.M1 RF433 Measurement of the noise level on the wireless module 1
(433MHz section)
z
Monit.M1 RF868 Measurement of the noise level on the wireless module 1
(868MHz section)
z
Monit.M2 RF433 Measurement of the noise level on the wireless module 2
(433MHz section)
z
Monit.M2 RF868 Measurement of the noise level on the wireless module 2
(868MHz section)
z
Reception Test of wireless data reception
z
Con. sirens Test of communication with the wireless sirens
z
Con. consoles Test of communication with the wireless consoles
MONITOR RF
Permits measuring of the medium noise level in the place the control panel (module)
is installed. The noise level measured can be included in three ranges:
z
Inferior to -95dBm (medium-low noise level)
The control panel is working without any problem. The noise level does not
disturb the smooth functioning of the wireless section.
z
Included between -95dBm and -75dBm (medium-high noise level)
If the noise level is constantly remains at this level there might be problems for
the smooth functioning of the wireless section.
z
Included between -75dBm and -55dBm (high noise level)
The wireless section is disturbed (does not work).
Commands available
+
EXIT to quit the submenu
RECEPTION
Permits testing of the correct reception of wireless data transmitted by the devices
associated. Remember that the wireless devices must have been learnt beforehand.
For test put the devices into the test mode.
Commands available
+
EXIT to quit the submenu
COMMUNICATION WITH THE WIRELESS SIRENS
Permits testing of the communication between the control panel and the wireless
sirens. The test takes approx. 8 seconds and checks the correct data transmission/
reception of all the wireless sirens associated to the control panel (max. 4).
Communication issues
On the display are viewed the communication issues separately for all four wireless
sirens (S1, S2, S3 and S4):
z
Yes Communication (TX/RX) without errors
z
No Communication (TX/RX) with negative issue
z
- - - No wireless siren associated to this position
Commands available
+
EXIT to quit the submenu