Tecnoalarm TP16-256, Руководство по установке

Страница: 56 / 248

Hardware - Output Expansion Modules Installer Manual - TP16-256
2D-2
2D.1.3 INSTALLATION
The ESP32-OCN output expansion module must be mounted inside a special tamper-protected metal casing.
The tamper switches against opening and wrenching must always be connected in series to the tamper line of the
control panel. The antiopening switch is positioned right behind the casing cover, whereas the anti-wrenching is
positioned on the reat side of the casing.
Once you have installed the tamper switch against wrenching, fix the casing to the wall using the dowels and screws
included.
2D.2 SUPERVISORY BOARD WITH SIGNALING LED SINOTTICO 32N
The supervisory board SINOTTICO 32N provides 32 signaling LED for supplementary system status signaling.
The supervisory board must be connected via serial bus RS485 and configurated by SW1 dip-switch.
2D.2.1 ELECTRONIC BOARD
2D.3 NOTES FOR ALL OUTPUT EXPANSIONS
END OF SERIAL BUS
The end-of-serial-bus jumper is to be inserted on the last device connected in series only.
2D.4 DIP-SWITCH SETTINGS
The SW1 dip-switch permits programming of the address of the modules on serial bus. There must not be two
devices with the same address.