Tecnoalarm TP16-256, Руководство по установке

Страница: 173 / 248

TP16-256 - Installer Manual Programming by Console
5-33
Options 8
Rpt. loc. msg [ ]
Options 9
Volume low [ ]
Options 10
Key sin. arm. [ ]
Options 11
Inv.dig.prot. [ ]
Options 12
Modif. codes [ ]
Options 13
Radio mode [ ]
Options 6
Siren AM [ ]
Options 7
Key ON/OFF [ ]
z
Siren AM (enabling of siren activation for antimasking alarm)
Permits enabling/disabling of supervision alarm signaling through the sirens. The
sirens observe the tamper alarm time.
[ # ]
Siren activation for antimasking alarm enabled
z
Key ON/OFF
Defines the functioning mode of the key zone:
[ ]
Pulse (permitting the connection of a button)
[ # ] ON/OFF (permitting the connection of a mechanic key)
z
Rpt.loc.msg (enabling of sound report)
Enables the console for playing back voice messages describing all the
operations being executed and events occurring.
[ # ]
Sound report enabled
z
Key sin. arm. (single arming by key)
Enables the keys for single arming only (relevant for key readers connected to
key interface only, not valid for key readers with minikeypad), even if they are
enabled for several programs. On every introduction of the key into the key
reader a different program is armed.
[ # ]
Arming by key singlularly only
z
Inv.dig.prot. (inversion of digital protocols)
Permits the inversion of the figures sent during digital transmissions.
[ # ]
Inversion of the digital protocols
z
Modif. codes (user code modification)
Permits enabling/disabling of the modification of the standard user codes by the
holder of the codes themselves. If the user code modification is disabled, merely
the holder of the master will be entitled to change the standard user codes. If it is
enabled, the user will however only be entitled to change its own code and in no
case that of the other users.
[ # ]
User code modification enabled
z
Radio mode (wireless transmission mode)
Every wireless transmission mode a different transmission power of the wireless
receiver-transmitter (RTX200/433868) is assigned:
„
System 1
„
System 2
„
System 3
z
Tamper
Defines the tamper control mode:
„
Counter (i.e. number of zone openings 1 to 255)
„
Timeout (hours : minutes)
z
AM Zones (enabling of antimasking alarm zones)
Defines the antimasking control mode:
„
Always active
„
Al. if P armed
„
If P armed
Viewing of the current settings
[ ] Option not enabled
[ # ] Option enabled
Commands available
+
#
YES to enable the option selected
+
*
NO to disable the option selected
+
EXIT to accept programming and quit the submenu
Options 14
Tamper [ ]
Options 15
AM Zones [ ]