Tecnoalarm TP16-256, Руководство по установке

Страница: 132 / 248

Programming by PC Installer Manual - TP16-256
4-40
PROGRAMMING OF THE ATTRIBUTES
To associate the attributes to the key check the relevant item.
z
By-pass
If checked, the meaning of arming and disarming of the
programs associated change:
• Arming program becomes Start by-pass program
• Disarming program becomes End by-pass program
• Disarming becomes End of by-pass
z
By-pass general alarms
If checked, the user will be entitled to arm the system even
in presence of a general alarm (i.e. tamper, low battery,
power failure, supervision, trouble modules)
z
Automatic communicator block on disarming
If checked, upon disarming of the system (pressing the
corresponding function key) the active telephone channels
(and those queued up) are blocked automatically.
z
Confirmation of disarming (hold-up block)
Activates the hold-up function on the wireless key. In this
case, disarming by this wireless key will have to be
confirmed by entering of a valid user code within a
determined period of time (disarming confirmation delay),
otherwise a silent hold-up alarm will be released.
z
Hold-up
If checked, it is possible to release a hold-up (panic) alarm
and activate the relative output by pressing simultaneously
the keys 2 and 3 of the wireless key.
z
Exclusion disabled
If checked, the user will
not be entitled to arm the control
panel excluding some of the zones (both voluntary and
automatic zone exclusion are disabled). The control panel
will be armed in any case, and if there are open zones,
the alarm will be released.
z
Siren impulse on arming
If enabled, on arming of the control panel, the siren is
actived for a few seconds (1 impulse).
Repeat the procedure for all the wireless keys (1 to 60).
Once you have finished programming of the wireless keys,
press:
z
OK to confirm and close the code configuration
tables
z
Abandon to undo programming and close the code
configuration tables