Tecnoalarm TP16-256, Руководство по установке

Страница: 97 / 248

TP16-256 - Installer Manual Programming by PC
4-5
Repeat the operations for every zone to be configured (up to a maximum of 256).
Once you have created the zone list, press:
z
OK to confirm and close the zone configuration tables
z
Abandon to cancel the zone parameters entered
PROGRAMMING OF A DEVICE CONNECTED VIA ZONE BUS
Type
Select the type from the devices listed (WINBEAM/S from 2 to 5 beams - DOORBEAM/S from 6 to 8 beams)
Beams
Permits enabling/disabling of determined beams (the flag indicates that the beam has been enabled)
Position cable
Permits the selection of the cable position (top/bottom)
Response time
Permits programming of the response time (T) of the device at two levels (0.2 seconds or 0.5 seconds)
Functioning mode
Permits the definition of the modality of alarm detection:
z
1 for 1 sec. or 2 adj. for T
The alarm is released if any beam is interrupted for 1 second or two adjacent beams for the response time (T)
programmed.
z
2 adj. for T
The alarm is released if two adjacent beams are interrupted for the response time (T) programmed.
z
3 adj. for T lower part or 2 adj. for T
The alarm is released if three adjacent beams in the lower part of the barrier or two adjacent beams are
interrupted for the response time programmed
z
1 for T
The alarm is released if any beam is interrupted for the response time programmed
Power
Permits programming of the beam power at four levels (off, low, medium, high)
Repeat the procedure for every zone to be configured (up to a total of 256).
Once all the zones have been configured, press:
z
OK to confirm and close the zone configuration tables
z
Abandon to cancel the zone parameters entered