SZGH SZGH-CNC1000MDb Series, Руководство пользователя

Страница: 130 / 223

-Shenzhen Guanhong Automation Co.,Ltd.- SZGH-CNC1000MDb Series
- 117 -
4.3.1.6 Huff(M59/M58)
M59: Turn on huff M58: Turn off huff
Remark PIN Function
M59 PIN6_CN10 Plug Turn on/off huff, also blower
4.3.1.7 Condition Output of Machine Tool(M65/M67/M69)
M65/M67/M69 be used for output condition of machine tool, set by parameters
Remark PIN Function
M65 PIN20_CN3 Plug Output Alarm condition of machine tool
M67 PIN8_CN3 Plug Output Running condition of machine tool
M69 PIN21_CN3 Plug Output Pausing condition of machine tool
Parameter sets for condition output of machine tool. In Other parameter:
P28: M65/M69 are as outputs for run/halt condition of machine tool,0:no,1:yes.
P29: M67 is as output for alarm condition of machine tool, 0: no, 1:yes.
Note:1.When M65,M67,M69 are used for output condition of machine tool, and then they can’t be used for
other functions.
2.Valid level of all output points is 0V. When fixed with inductance load, must connected with the reverse
diode to protect inner circuit of cnc system.
4.3.2 M Input Command List
No. Code Function Introduction Statement
1
M12 Check M12 is valid
These codes can be used for
conditional wait or conditional jump.
M13 Check M12 is invalid
2
M14 Check M14 is valid
M15 Check M14 is invalid
3
M16 Check M16 is valid
M17 Check M16 is invalid
4
M18 Check M18 is valid
M19 Check M18 is invalid
5
M28 Check M28 is valid
M29 Check M28 is invalid
6
M22 Check M22 is valid
M23 Check M22 is invalid
7
M24 Check M24 is valid
M25 Check M24 is invalid
Note: All M input commands, input effective level is 0V.
There are two kinds of special application about M input commands,as following,
a) Conditional Wait
Example: M12
When Input point M12 is valid, program goes on run following blocks, if M12 is invalid,
system will wait if M12 is valid.
b) Conditional Jump
Example: M14 P0120
When run this block and system detecting if M14 input signal is valid. When M14 is valid,
program jump to 120th line of program (N0120 block), otherwise system will execute next block.