-Shenzhen Guanhong Automation Co.,Ltd.-
SZGH-CNC1000MDb Series
- 109 -
Note: Q, P, L is invalid when using G112/G113, but value of Q & P will be remained as canned cycle.
Example
: Fine milling a rectangle groove that has been rough milled as follows by canned cycle
code G136. (D1=5).
G90 G00 X50 Y50 Z50 ;
Rapid Positioning
G99 G24 X10 Y10 Z-50 R5 I80 J50 K30 U10 D1 F800 ; CCW fine milling rectangle
G80 X50 Y50 Z50 ;
Cancel canned cancel and return to point R level
M30 ;
End of program
Note: 1. When use G112/G113 is used, G codes in 01 group cannot be used, otherwise G114/G115 is replaced by
other codes in group 1.
2. Tool radius compensation: in the fixed cycle command, the tool radius compensation is ignored, the
system calls the tool radius compensation specified by the program during the tool infeed.
3.31.9 Outer Rectangle Fine Milling Cycle (G138/G139)
The tool performs fine milling outside the rectangle by the specified width & direction, and it
returns after finishing the fine milling.
G138: CCW Outer Rectangle Fine Milling Cycle ; C139: CW Outer Rectangle Fine Milling
Cycle .
X_Y_: The starting point in XY plane
Z_ :
The distance from point R to the bottom of the hole
R_ :
The distance from the initial level to point R level
I_ :
Width of rectangle in X-axis
J_ :
Width of rectangle in Y-axis
K_ :
Distance from fine milling start point to rectangle side in X-axis
U_ :
Corner arc radius
D_ :
Tool radius offset number
F_ :
Cutting Feedrate
Note: 1. Width of rectangle in X-axis, I,Range is -99999999~99999999 (*min unit). Its absolute value is used if
it is negative.
2. Width of rectangle in Y-axis, J, Range is -99999999~99999999(*min unit). Its absolute value is used if
it is negative.
3. Distance from fine milling starting point to rectangle side in X-axis,K,is greater than radius of tool. Its
absolute value is used if it is negative.
4. No corner transition if corner arc radius, U, is omitted.
5. Range of Tool radius offset number , D, is 0~32. default is 0.
Содержание SZGH-CNC1000MDb Series
Страница 220: ...Shenzhen Guanhong Automation Co Ltd SZGH CNC1000MDb Series 207 Appendix I Wiring Diagram of CN3 Plug...
Страница 221: ...Shenzhen Guanhong Automation Co Ltd SZGH CNC1000MDb Series 208 Appendix II Wiring Diagram of CN10 Plug...
Страница 222: ...Shenzhen Guanhong Automation Co Ltd SZGH CNC1000MDb Series 209 Appendix III Wiring Diagram of CN4 Plug...
