-Shenzhen Guanhong Automation Co.,Ltd.-
SZGH-CNC1000MDb Series
VI
cover). Touching the uncovered high
–
voltage circuits presents an extremely dangerous electric shock hazard.
NOTE:The absolute pulse coder uses batteries to preserve its absolute position. If the battery voltage drops, a
low battery voltage alarm is displayed on the machine operator’s panel or screen. When a low battery voltage
alarm is displayed, replace the batteries within a week. Otherwise, the absolute position data held by the pulse
coder will be lost.
3. Fuse replacement
For some units, the chapter covering daily maintenance in the operator
’
s manual or programming manual
describes the fuse replacement procedure.
Before replacing a blown fuse, however, it is necessary to locate and remove the cause of the blown fuse. For this
reason, only those personnel who have received approved safety and maintenance training may perform this work.
When replacing a fuse with the cabinet open, be careful not to touch the high
–
voltage circuits (marked and fitted
with an insulating cover).
Touching an uncovered high
–
voltage circuit presents an extremely dangerous electric shock hazard.
Special Attention:
1. All the functions of A axis & B axis on system are effective when configure with fourth axis & fifth axis.
2. When use this system for the first time, please read carefully all the details of each chapter so as to make it
work more efficiency and safer.
3. The “Run” button on the panel of system can be used when debugging (P9 in Other parameter to set
“Valid” or “Invalid”), must plus an external “Run” button when fitting system, otherwise may cause accident
because of the life of button!!!So the system prohibits using the “Run” button of panel for long times,
otherwise the consequences has nothing to do with my company.
4. Don’t plug & insert connectors when system is on power.
5. We will use some short name to stands for parameter number. For example: P -- Parameter , P1 stands for
the No.1 parameter .Example: P9-D6,also No.9 parameter, No.7 bit from right to left side.
6. There are some bit parameters on CNC system, different bit parameters have different means, some bit
parameters are for inner system,don’t change these bits parameter we don’t explain,keep same as ex-factory
set.
Содержание SZGH-CNC1000MDb Series
Страница 220: ...Shenzhen Guanhong Automation Co Ltd SZGH CNC1000MDb Series 207 Appendix I Wiring Diagram of CN3 Plug...
Страница 221: ...Shenzhen Guanhong Automation Co Ltd SZGH CNC1000MDb Series 208 Appendix II Wiring Diagram of CN10 Plug...
Страница 222: ...Shenzhen Guanhong Automation Co Ltd SZGH CNC1000MDb Series 209 Appendix III Wiring Diagram of CN4 Plug...