SZGH SZGH-CNC1000MDb Series, Руководство пользователя

Страница: 182 / 223

-Shenzhen Guanhong Automation Co.,Ltd.- SZGH-CNC1000MDb Series
- 169 -
These are range that system can detect Z0 signal of encoder of feeding-axis.
Attention:the value must be less than the length of one rev,otherwise homing failure.
46,Offset after homing in X axis (unit:10um,-9999~+9999)
47,Offset after homing in Y axis (unit:10um,-9999~+9999)
48,Offset after homing in Z axis (unit:10um,-9999~+9999)
49,Offset after homing in X axis (unit:10um,-9999~+9999)
These are offset that feeding-axis after homing. Move with G00 speed. Unit: 0.01mm.
50,Spindle is rotating when shift gear [1:Yes, 0:No]
It set if spindle is rotating when spindle shift gears.1:Yes, SP is rotating, 0: No.
51,Rotating Speed of Spindle when shift gear(1/100rpm)
It is rotating speed of spindle when spindle shift gear & P51=1.
52,Rotating Direction of Spindle when shift gear [0:CW,1:CCW]
It is rotation direction of spindle when spindle shift gear. 0: CW(M03); 1:CCW(M04).
53,Braking Time of Spindle when shift gear (10ms)
It is braking time of spindle when spindle shift gear. Unit: 10ms.
54,Delay time between reset M03/M04 & set M05 (10ms)
It is delay time before output M05 ,and after reset M03/M04. Unit:10ms.
55,Spindle stop time(unit:10ms)
It is the delay time between cancel M03/M04 and boot M05.unit:10ms.
56,Detect SP_Position Feedback [0: No,1: Yes]
It is for whether the system detect position feedback signal of spindle by SP_encoder. 1: detect,
0: No detect.
It is used for open that display of spindle real speed & some functions related with SP_Speed
which must be on condition of transmission ratio is 1:1 between SP_encoder & spindle motor.
57,Pulses Per Revolution of Spindle
It is pulses per revolution of spindle. Pulses= (Resolution of SP-encoder) * 4.
57-1,Allow Error of Resolution of SP_Encoder[>10]
It sets resolution of spindle encoder,which is checked by CNC,also Spindle encoder check on
Alarm/diagnosis screen.Range is >10
57-2,Pulses Per Revolution of Spindle[1/1:0,Other:>99]
It set pulses of spindle per one revolution(Quadruple),when teeth on encoder & on spindle axle
is same(1:1), set P200-2 to 0. if not 1:1,valid range is >99,value must be integer.
66,Gear Shift Control on Spindle Axis[1:Yes, 0:No]
It sets whether set gear shift control on spindle axis.
68,Delay time when feeding axes shift direction(ms)
It sets delay time when feeding axes(XYZA) change direction, unit: ms.
69,Homing Mode of Manual return to home with keys(1:All, 0:Select)
It sets homing mode of press “Return” key, 1: all axes go home, 0: just selected axis go home.