SZGH SZGH-CNC1000MDb Series, Руководство пользователя

Страница: 144 / 223

-Shenzhen Guanhong Automation Co.,Ltd.- SZGH-CNC1000MDb Series
- 131 -
6.5.2 Manual Increment
This operation is to set the value of increment as the basis, press “↑ ↓ ← →” once to run a
value of increment. It will prompts “I=0010.000” in manual increment represent for the value of
increment is 10mm, press “I” to revise and Enter.
The speed is the speed on display(F) times the rate.
6.5.3 Manual pulse generator(Handwheel)
There are two types of handwheel, one is handwheel in handheld box; the other is handwheel
in the operational panel.
Handwheel in Handheld Box: Press “Handwheel” key to enter handwheel mode. User can
operate the axes selection & feeding override of handwheel(*1/*10/*100).
Handwheel is mainly used for “Tool”, also posit tool.
Speed of handwheel pulse generator should be lower than 200r/min(100 pulses per cycle).
Parameters set for handwheel
P1 in Other parameter is set for position of handwheel.
In Speed parameter:
P23 is set for acceleration / deceleration time constant.
P24 is set for acceleration / deceleration time constant when simulate.
P25 is set G00 speed when dry run with handwheel
P26 is set max speed of X-axis with handwheel.
P27 is set max speed of Y-axis with handwheel.
P28 is set max speed of Z-axis with handwheel.
P29 is set max speed of A-axis with handwheel.
In Axis parameter:
P311 is set max speed of B-axis with handwheel.
Note:
1. SZGH-CNC1000MDb series support handwheel in panel & in handheld box.
2. Handwheel is no effect in auto-coordinates diagram machining, it only works in mode of coordinates.
3. When system is configured with stepper system, feeding speed shouldn’t be too fast.
Fig6.3 Handheld Box(Manual Pulse Generator)