SZGH SZGH-CNC1000MDb Series, Руководство пользователя

Страница: 172 / 223

-Shenzhen Guanhong Automation Co.,Ltd.- SZGH-CNC1000MDb Series
- 159 -
38,Z_Homing Speed (mm/min)
It is homing speed of Z-axis.Unit:mm/min. the range is less than Z_G00 speed.
39,Z_Speed for detect Z0 signal (mm/min)
It is speed for off of homing switch and check Z0 pulse signal after Z-axis reach at homing
switch. Unit:mm/min. the range is 20-500.
Note:it is for ensure accuracy.the smaller it is ,the higher the accuracy is.when set well,don’t change it forever.
40,A_Homing Speed (mm/min)
It is homing speed of A-axis.Unit:mm/min. the range is less than X_G00 speed.
41,A_Speed for detect Z0 signal (mm/min)
It is speed for off of homing switch and check Z0 pulse signal after A-axis reach at homing
switch. Unit:mm/min. the range is 20-500.
note:it is for ensure accuracy.the smaller it is ,the higher the accuracy is.when set well,don’t change it forever.
42,Max Speed of 1st Spindle (rpm)
It is max speed of 1st spindle, also at 1st gear,M41 output for 1st gear, it is also the speed when
PIN25_CN3 plug output analog voltage is 10V(Default condition).
43,Max Speed of Spindle at 2nd gear (rpm)
It is max speed of spindle at 2nd gear,M42 output for 2nd gear, it is also the speed when
PIN25_CN3 plug output analog voltage is 10V at M42.
44,Max Speed of Spindle at 3rd gear (rpm)
It is max speed of spindle at 3rd gear,M43 output for 3rd gear, it is also the speed when
PIN25_CN3 plug output analog voltage is 10V at M43.
45,Max Speed of Spindle at 4th gear (rpm)
It is max speed of spindle at 4th gear,M44 output for 4th gear, it is also the speed when
PIN25_CN3 plug output analog voltage is 10V at M44.
46,Max Speed of 2nd Spindle (rpm)
It is the max speed of 2nd spindle,it is also the speed when PIN25_CN10 plug output analog
voltage is 10V. Specified by “SS#” , unit is rpm.
47,Compensation Mode of Arc Backlash (0 mean A; 8 mean B)
It is compensation mode for arc reverse backlash.
0 means A compensation mode, which is that the bigger the reverse backlash is ,the faster the
compensation speed is , in order to ensure tool don’t exit pause condition. the compensation speed
is less than 1000mm/min.
8 means B compensation mode , which is that the compensation speed is set by related
parameters in the following.
+4: means when arc programming, IJK is the coordinate value from end point to center. In the