STC SmartScanIS, Руководство пользователя

Страница: 114 / 391

114
14 January 2021, SmartScanIS User’s Guide for Union Pacific, EUD-2016026-00 Rev.2
For the Type III wheel scanner, the large hole is on the side of the mount (2500-401)
farthest from the track. Some of these scanners have two ground lugs, as shown
below.
13 Using a T-handle 3/16-inch hex-wrench, remove the two socket-head-cap screws.
14 Store the screws, washer, and ground lug (or ground lugs) in a safe place until you're
ready to use them.
In the steps that follow, the terms scanner cable connector, panel connector, and
flex-conduit-adapter plate are used. Notice where they are on a wheel scanner cable.
Single-track sites have two 65-foot (19.8-meter) wheel scanner cables. Double-track
sites have two 65-foot wheel scanner cables for the track closest to the bungalow. For
the track farthest from the bungalow, they have either two 85-foot (25.9-meter) or two
100-foot (30.5-meter) wheel scanner cables.
15 If this is a double-track site, select the correct length of cable.
16 Tighten the locking nut (on the conduit connector) until it is tight against the
flex-conduit-adapter plate.
17 Put the scanner cable connector through the round hole in the side of the mount.
18 Align the screw holes in the flex-conduit-adapter plate with the screw holes in the
mount.