STC SmartScanIS, Руководство пользователя

Страница: 223 / 391

EUD-2016026-00 Rev.2, SmartScanIS User’s Guide for Union Pacific, 14 January 2021
223
13 To set or change the gate distance (aka gate width) value:
The Equipment submenu shows the number of inches between the centers of the
gating transducers.
•
•
•
I) Sliding Wheel............... YES
J) Gate Distance....... 24.0 inches
K) Cold Wheel.................. YES
L) Resistor Integ. Test.... Enabled
M) Modem Type:.............. Analog
N) Min. Transducer Pulse Width. 3mS
O) Cold Rail Test....... All Trains
Equipment to change or Esc to quit?
a From the Equipment submenu, select Gate Distance .
This prompt appears.
Gate Distance:
The format for gate width (gate distance) is nn.n . If the new value has less than
three digits, type leading zeros, trailing zeros, or both. Thus, for 2, type 020 . The
system inserts the decimal point for you. The gate width (it is usually 24.0) can be
recorded in 1/10-inch increments to reflect the actual transducer spacing. Accurate
gating-transducer spacing results in accurate speed calculations.
b Enter the three-digit number.
The Gate Width option on the Equipment submenu changes. The Equipment
submenu reappears.
c Return to step 3 .