Standard 1460, Руководство пользователя

Страница: 111 / 128

1464 INSTALLATION INSTRUCTIONS
445734 Issue I Rev. A
Page 3 of 6
4-20-95
For the Addition of 1464 Quad Auxiliary Circuit Module
Into 1462 / TC1262 Program Time Controller
Ensure that all necessary parts for the 1464 module are included in the package.
Check items against the following parts list:
DESCRIPTION QTY PART NO.
Quad Aux Ckt Board 1 413169
Cable Assy, 5 in. 1 444872
Spacer - 1-5/8" 4 444840
II.) ADDING 1464 TO 1462 or TC1262:
NOTE: If the 1462/TC1262 is already in use, remove AC power before proceeding with installation of the module.
CAUTION: Shock hazard inside Program Time Controller. Remove all power before servicing.
1.) Remove the cover.
2.) Remove the 4 Keps nuts that match the mounting holes of the 1464 to be installed.
3.) Place the four 1-5/8" spacers provided on the exposed studs.
4.) Place the 1464 on the spacers with the terminals towards the bottom of the cabinet. Secure the board in place
with the nuts which were removed in step 2.
5.) Connect the cable between the header J3 on the main board and the header J1 on the 1464. WARNING: Make
sure the cable is seated correctly and proper polarity was observed. Improper installation may damage
the 1464 and/or the 1462/TC1262.
6.) It is recommended that AC power be temporarily applied to the unit so that the 1464 module can be tested to
ensure proper operation by means of the 1462/TC1262 Diagnostics Routine or by manual activation of the
auxiliary circuits.
7.) Remove AC power.
8.) Connect all field wires and add new auxiliary circuit wiring as required.
9.) Reattach cover.
10.) Connect AC power.
firealarmresources.com