Sonifex COURIER, Руководство пользователя

Страница: 174 / 218

Chapter 13 - courier configuration manager
13-12 Courier User Handbook
13.3. Transferring files between the Courier
and a PC using the CCM software
With the CCM v3 software, files can be transferred to and received from a PC
connected to a Courier by using a serial or USB cable. This is useful for :
1. Transferring Setup .ini files, created by the Courier Configuration Manager
program, to the Courier so that they can be loaded using the [Read Setup]
command.
2. Transferring Courier firmware from the PC to the Courier. Courier firmware
can be found on the Sonifex website (see the address inside the opening page of
this handbook) and copied to your PC across the web. It can then be loaded into
the Courier by using the [Load Firmware] command – See appendix A for
further information.
3. Transferring audio recorded on the Courier to a PC for editing, if the PC has no
PCMCIA slot available.
13.3.1. Setting up the Courier comms options
for PC connection
Courier currently only has one option for the RS232 port, which is to change the
baud rate. The RS232 port is the one used to connect to a COM port of the PC.
Press the MENU key in the Cut-List Mode and select [Setup], [System], [Comms
Setup] and [Baud] to show :
Initially, try selecting the highest baud rate possible, 115200, and see if this works
when connected to the PC. If this does not work, try lower values until a connection
is established. Note that this value must be the same as the [Baud Rate] setting on
the PC software.
Select [Close] to exit without making any changes.