SMC Networks LECSB Series, Руководство по эксплуатации

Страница: 60 / 423

3 - 24
3. SIGNALS AND WIRING
Device Symbol
Connec-
tor pin
No.
Functions/Applications
I/O
division
Control
mode
P S T
External torque
limit selection
TL CN1-18 Turn TL off to make Forward torque limit (parameter No.PA11) and
Reverse torque limit (parameter No.PA12) valid, or turn it on to
make Analog torque limit (TLA) valid.
For details, refer to section 3.6.1 (5).
DI-1
Internal torque
limit selection
TL1 When using this signal, make it usable by making the setting of
parameter No.PD03 to PD08, PD10 to PD12.
For details, refer to section 3.6.1 (5).
DI-1
Forward rotation
start
ST1 CN1-17 Used to start the servo motor in any of the following directions. DI-1
(Note) Input device
Servo motor starting direction
ST2 ST1
0 0 Stop (servo lock)
Reverse rotation
start
ST2 CN1-18 0 1 CCW
1 0 CW
1 1 Stop (servo lock)
Note. 0: off
1: on
If both ST1 and ST2 are switched on or off during operation, the
servo motor will be decelerated to a stop according to the parameter
No.PC02 setting and servo-locked.
When " 1" is set in parameter No.PC23, the servo motor is not
servo-locked after deceleration to a stop.
Forward rotation
selection
RS1 CN1-18 Used to select any of the following servo motor torque generation
directions.
DI-1
(Note) Input device
Torque generation direction
RS2 RS1
0 0 Torque is not generated.
Reverse rotation
selection
RS2 CN1-17
0 1
Forward rotation in driving mode/
reverse rotation in regenerative mode
1 0
Reverse rotation in driving mode/
forward rotation in regenerative mode
1 1 Torque is not generated.
Note. 0: off
1: on