SMC Networks LECSB Series, Руководство по эксплуатации

Страница: 184 / 423

6 - 8
6. DISPLAY AND OPERATION SECTIONS
6.4 Diagnostic mode
Name Display Description
Sequence
Not ready.
Indicates that the driver is being initialized or an alarm has occurred.
Ready.
Indicates that the servo was switched on after completion of
initialization and the driver is ready to operate.
External I/O signal display
Refer to section 6.7. Indicates the ON-OFF states of the external I/O signals.
The upper segments correspond to the input signals and the lower
segments to the output signals.
Lit: ON
Extinguished: OFF
Output signal (DO) forced
output
The digital output signal can be forced on/off. For more information,
refer to section 6.8.
Test
operation
mode
JOG
operation
JOG operation can be performed when there is no command from
the external command device.
For details, refer to section 6.9.2.
Positioning
operation
Positioning operation can be performed when there is no command
from the external command device.
The software (MR Configurator2
TM
) is required for positioning
operation.
For details, refer to section 6.9.3.
Motorless
operation
Without connection of the servo motor, the driver provides output
signals and displays the status as if the servo motor is running
actually in response to the input device.
For details, refer to section 6.9.4.
Machine
analyzer
operation
Merely connecting the driver allows the resonance point of the
mechanical system to be measured.
The software (MR Configurator2
TM
) is required for machine analyzer
operation.
For details, refer to section 12.8.
Driver
diagnosis
Simple diagnosis as to correct function of the input/output interface of
the driver can be made. To diagnose the driver, the diagnosis cable
(MR-J3ACHECK : Mitsubishi Electric Corporation) and software (MR
Configurator2
TM
) are necessary.
Software version low Indicates the version of the software.
Software version high Indicates the system number of the software.