SMC Networks LECSB Series, Руководство по эксплуатации

Страница: 23 / 423

1 - 6
1. FUNCTIONS AND CONFIGURATION
Function Description
(Note)
Control mode
Reference
Electronic gear Input pulses can be multiplied by 1/50 to 50. P
Parameters
No.PA06, PA07
Auto tuning
Automatically adjusts the gain to optimum value if load applied
to the servo motor shaft varies.
P, S Chapter 7
Position smoothing Speed can be increased smoothly in response to input pulse. P Parameter No.PB03
S-pattern acceleration/
deceleration time constant
Speed can be increased and decreased smoothly. S, T Parameter No.PC03
Return converter
Used when the regenerative option cannot provide enough
regenerative power.
P, S, T Section 12.4
Alarm history clear Alarm history is cleared. P, S, T Parameter No.PC18
Restart after instantaneous
power failure
If the input power supply voltage had reduced to cause an
alarm but has returned to normal, the servo motor can be
restarted by merely switching on the start signal.
S Parameter No.PC22
Command pulse selection
Command pulse train form can be selected from among three
different types.
P Section 5.1.12
Input signal selection
(Device settings)
Forward rotation start, reverse rotation start, servo-on (SON)
and other input device can be assigned to certain pins of the
CN1 connectors.
P, S, T
Parameters
No.PD03 to PD08,
PD10 to PD12
Output signal selection
(Device settings)
Trouble (ALM), dynamic brake interlock (MBR) and other
output device can be assigned to certain pins of the CN1
connectors.
P, S, T
Parameters
No.PD13 to PD16,
PD18
Torque limit Servo motor torque can be limited to any value. P, S
Section 3.6.1 (5)
Section 5.1.11
Speed limit Servo motor speed can be limited to any value. T
Section 3.6.3 (3)
Parameter
No.PC05 to PC11
Status display Servo status is shown on the 5-digit, 7-segment LED display P, S, T Section 6.3
External I/O signal display
ON/OFF statuses of external I/O signals are shown on the
display.
P, S, T Section 6.7
Output signal (DO)
forced output
Output signal can be forced on/off independently of the servo
status.
Use this function for output signal wiring check, etc.
P, S, T Section 6.8
Automatic VC offset
Voltage is automatically offset to stop the servo motor if it does
not come to a stop at the analog speed command (VC) or
analog speed limit (VLA) of 0V.
S, T Section 6.4
Test operation mode
JOG operation, positioning operation, motor-less operation,
DO forced output and program operation.
However, Set up software(MR Configurator2
TM
) is necessary
for positioning operation and program operation.
P, S, T Section 6.9
Analog monitor output Servo status is output in terms of voltage in real time. P, S, T Parameter No.PC14
Set up software
(MR Configurator2
TM
)
Using a personal computer, parameter setting, test operation,
status display, etc. can be performed.
P, S, T Section 12.8
Alarm code output
If an alarm has occurred, the corresponding alarm number is
output in 3-bit code.
P, S, T Section 9.1
Note. P: Position control mode, S: Speed control mode, T: Torque control mode
P/S: Position/speed control change mode, S/T: Speed/torque control change mode, T/P: Torque/position control change mode