Siemens SINUMERIK 828D Turning, Руководство по эксплуатации

Страница: 587 / 940

Requirement
For a G code program, at least one CYCLE62 is required before CYCLE952.
If CYCLE62 is only present once, then this involves the finished part contour.
If CYCLE62 is present twice, then the first call is the blank contour and the second call is the
finished-part contour (see also Section "Programming (Page 574)").
Note
Execution from external media
If you execute programs from an external drive (e.g. local drive or network drive), you require
the "Execution from external storage (EES)" function.
For additional information, please refer to the following documentation:
SINUMERIK Operate Commissioning Manual
Rule
With the "Execution from External Storage (EES)" function, you have the option to access any
logical drive with part programs – and to directly process them as if through the NC program
memory.
Rounding the contour
In order to avoid residual corners during roughing, you can enable the "Always round the
contour" function. This will remove the protrusions that are always left at the end with each cut
(due to the cut geometry). The "Round to the previous intersection" setting accelerates
machining of the contour. However, any resulting residual corners will not be recognized or
machined. Thus, it is imperative that you check the behavior before machining using the
simulation.
When set to "automatic", rounding is always performed if the angle between the cutting edge
and the contour exceeds a certain value. The angle is set in a machine data element.
Machine manufacturer
Please observe the information provided by the machine manufacturer.
Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
587