Samsung SC32442B54, Руководство пользователя

Страница: 401 / 647

SC32442B RISC MICROPROCESSOR LCD CONTROLLER
15-29
LCD Control 3 Register
Register Address R/W Description Reset Value
LCDCON3 0X4D000008 R/W LCD control 3 register 0x00000000
LCDCON3 Bit Description Initial state
HBPD (TFT) [25:19]
TFT
: Horizontal back porch is the number of VCLK periods between
the falling edge of HSYNC and the start of active data.
0000000
WDLY (STN)
STN
: WDLY[1:0] bits determine the delay between VLINE and VCLK
by counting the number of the HCLK. WDLY[7:2] are reserved.
00 = 16 HCLK, 01 = 32 HCLK, 10 = 48 HCLK, 11 = 64 HCLK
HOZVAL [18:8]
TFT/STN
: These bits determine the horizontal size of LCD panel.
HOZVAL has to be determined to meet the condition that total bytes
of 1 line are 4n bytes. If the x size of LCD is 120 dot in mono mode,
x=120 cannot be supported because 1 line consists of 15 bytes.
Instead, x=128 in mono mode can be supported because 1 line is
composed of 16 bytes (2n). LCD panel driver will discard the
additional 8 dot.
00000000000
HFPD (TFT) [7:0]
TFT
: Horizontal front porch is the number of VCLK periods between
the end of active data and the rising edge of HSYNC.
0X00
LINEBLANK
(STN)
STN
: These bits indicate the blank time in one horizontal line
duration time. These bits adjust the rate of the VLINE finely.
The unit of LINEBLANK is HCLK x 8.
Ex) If the value of LINEBLANK is 10, the blank time is inserted to
VCLK during 80 HCLK.
Programming NOTE
: In case of STN LCD, (LIN WLH + WDLY) value should be bigger than (14+12Tmax).
(LIN WLH + WDLY)
≥
(14 + 8xT
max1
+ 4xT
max2
= 14 + 12T
max
)
LEGEND :
(1) 14: SDRAM Auto refresh bus acquisition cycles
(2) 8x Tmax1 : Cache fill cycle X the Slowest Memory access time(Ex, ROM)
(3) 4x Tmax2 : 0xC~0xE address Frame memory Access time