Samsung SC32442B54, Руководство пользователя

Страница: 320 / 647

UART SC32442B RISC MICROPROCESSOR
11-12
Tx Interrupt Type [9] Interrupt request type.
0 = Pulse (Interrupt is requested as soon as the Tx buffer becomes
empty in Non-FIFO mode or reaches Tx FIFO Trigger Level in FIFO
mode.)
1 = Level (Interrupt is requested while Tx buffer is empty in Non-
FIFO mode or reaches Tx FIFO Trigger Level in FIFO mode.)
0
Rx Interrupt
Type [8] Interrupt request type.
0 = Pulse (Interrupt is requested the instant Rx buffer receives the
data in Non-FIFO mode or reaches Rx FIFO Trigger Level in FIFO
mode.)
1 = Level (Interrupt is requested while Rx buffer is receiving data in
Non-FIFO mode or reaches Rx FIFO Trigger Level in FIFO mode.)
0
Rx Time Out
Enable [7] Enable/Disable Rx time out interrupt when UART FIFO is enabled.
The interrupt is a receive interrupt.
0 = Disable 1 = Enable
0
Rx Error Status
Interrupt Enable [6] Enable the UART to generate an interrupt upon an exception, such
as a break, frame error, parity error, or overrun error during a
receive operation.
0 = Do not generate receive error status interrupt.
1 = Generate receive error status interrupt.
0
Loopback Mode [5] Setting loopback bit to 1 causes the UART to enter the loopback
mode. This mode is provided for test purposes only.
0 = Normal operation 1 = Loopback mode
0
Send Break
Signal [4] Setting this bit causes the UART to send a break during 1 frame
time. This bit is automatically cleared after sending the break signal.
0 = Normal transmit 1 = Send break signal
0
Note
You should add following codes after selecting or deselecting the FCLK/n.
rGPHCON = rGPHCON & ~(3<<16); //GPH8(UEXTCLK) input
Delay(1); // about 100us
rGPHCON = rGPHCON & ~(3<<16) | (1<<17); //GPH8(UEXTCLK) UEXTCLK