Samsung SC32442B54, Руководство пользователя

Страница: 210 / 647

SC32442B RISC MICROPROCESSOR CLOCK & POWER MANAGEMENT
7
-
1
7
CLOCK & POWER MANAGEMENT
OVERVIEW
The Clock & Power management block consists of three parts: Clock control, USB control, and Power control.
The Clock control logic in SC32442B can generate the required clock signals including FCLK for CPU, HCLK for
the AHB bus peripherals, and PCLK for the APB bus peripherals. The SC32442B has two Phase Locked Loops
(PLLs): one for FCLK, HCLK, and PCLK, and the other dedicated for USB block (48Mhz). The clock control logic
can make slow clocks without PLL and connect/disconnect the clock to each peripheral block by software, which
will reduce the power consumption.
For the power control logic, the SC32442B has various power management schemes to keep optimal power
consumption for a given task. The power management block in the SC32442B can activate five modes: NORMAL
mode, SLOW mode, IDLE mode, STOP mode, Deep-STOP mode and SLEEP mode.
NORMAL mode:
The block supplies clocks to CPU as well as all peripherals in the SC32442B. In this mode, the
power consumption will be maximized when all peripherals are turned on. It allows the user to control the
operation of peripherals by software.
For example, if a timer is not needed, the user can disconnect the
clock(CLKCON register) to the timer to reduce power consumption.
SLOW mode:
Non-PLL mode. Unlike the Normal mode, the Slow mode uses an external clock (XTIpll or
EXTCLK) directly as FCLK in the SC32442B without PLL. In this mode, the power consumption depends on the
frequency of the external clock only. The power consumption due to PLL is excluded.
IDLE mode:
The block disconnects clocks (FCLK) only to the CPU core while it supplies clocks to all other
peripherals. The IDLE mode results in reduced power consumption due to CPU core. Any interrupt request to
CPU can be woken up from the Idle mode.
STOP mode:
STOP mode freezes all clocks to the CPU as well as peripherals by disabling PLLs. The power
consumption is only due to the leakage current in SC32442B. Activating external interrupt pins, TICK (RTC) or
RTC alarm can do the wake-up from STOP mode.
Deep-STOP mode:
Deep-STOP mode cut off the internal arm block using power cut off switch and freezes all
clocks to the logic as well as peripherals by disabling PLLs. This mode is for minimizing leakage and decrease the
wakeup time. Activating external interrupt pins, TICK (RTC) or RTC alarm can do the wake-up from Deep-STOP
mode.
SLEEP mode:
The block disconnects the internal power. So, there occurs no power consumption due to CPU
and the internal logic except the wake-up logic in this mode. Activating the SLEEP mode requires two
independent power sources. One of the two power sources supplies the power for the wake-up logic. The other
one supplies other internal logics including CPU, and should be controlled for power on/off. In the SLEEP mode,
the second power supply source for the CPU and internal logics will be turned off. The wakeup from SLEEP mode
can be issued by the EINT[15:0] or by RTC alarm interrupt.