97
Instruction Manual
11. Over Travel
Serial Detection Method
오버트레벨
해제방법
Resetting
Over Travel
『Err.011 OVER 』가 발생한 경우의 안전회피방향은 통상 “-측”이고,
안전회피방향으로의 해제는 이하의 순서로 실시합니다.
단, 이때 위험방향인 “+”방향으로는 [INS]를 눌러도 이동하지 않습니다.
① [RESET]를 눌러서 Err.011을 리셋합니다.
② 모드를 MANUAL 모드로 합니다.
③ JOG키의 [DEL]로 안전회피방향인 “-방향”으로 이동시킵니다.
[HI]를 누르면서의 JOG조작은 고속으로 회전합니다.
또한 『Err.012 OVER TRAVEL -』가 발생한 경우의 안전회피방향은 통상 “+측”이고,
안전회피방향으로의 해제는 이하의 순서로 행합니다.
마찬가지로 위험방향인 “-”방향으로는 [DEL]을 눌러도 이동하지 않습니다.
① [RESET]를 누르고 Err.012를 리셋합니다.
② 모드를 MANUAL 모드로 합니다.
③ JOG키의 [INS]로 안전회피방향인 “-방향”으로 이동시킵니다.
[HI]를 누르면서의 JOG조작은 조송으로 회전합니다.
At「Err.011 OVER 」, the safe avoiding direction is normally ' - ' side.
The reset to the safe avoiding direction is carried out in the following procedures.
In this case, even if the [INS] is pressed, it does not move to '+' side.
① Press [RESET] to reset Err.011.
② Change the mode to MANUAL.
③ With the [DEL] of the JOG key, move to the ' - ' side which is the safe avoiding direction.
The JOG operation by pressing [HI] will rotate the table in rapid traverse.
The JOG operation by pressing [HI] will rotate the table in rapid traverse.
At「Err.012 OVER TRAVEL-」, the safe avoiding direction is normally '+' side.
The reset to the safe avoiding direction is carried out in the following procedures.
For the same reason, ' - ' movement is not carried out even if the [DEL] is pressed.
① Press [RESET] to reset Err.012.
② Change the mode to MANUAL.
③ With the [INS] of the JOG key, move to the ' - ' side which is the safe avoiding direction.
The JOG operation by pressing [HI] will rotate the table in rapid traverse.
강제이동 방법
Forced
Movement
Method
『Err.011 OVER 』 발생시에 +방향으로의 강제이동을 실시하는 방법은 이하의
순서로 실시합니다.
① [RESET]를 누르고, Err.011을 리셋합니다.
② 모드를 MANUAL 모드로 합니다.
③ [HI]을 누른 상태에서 [INS]를 누르면 위험방향인 “+방향”으로 이동합니다.
『Err.012 OVER TRAVEL -』의 강제이동은 이하의 순서로 행합니다.
① [RESET]를 누르고 Err.012를 리셋합니다.
② 모드를 MANUAL 모드로 합니다.
③ [HI]을 누른 상태에서 [DEL]을 누르면 위험방향인 “-방향”으로 이동합니다.
강제이동을 할 때의 회전속도는 0.5min ̄¹로 고정됩니다.
At「Err.011 OVER 」, forced movement to '+' direction can be carried out in the following procedures.
① Press [RESET] to reset Err.011.
② Change the mode to MANUAL.
③ With [HI] being pressed, press [INS] to move to the '+' direction which is the risky direction.
Forced movement at「Err 012 OVER TRAVEL-」can be carried out in the following procedures.
① Press [RESET] to reset Err.012.
② Change the mode to MANUAL.
③ With [HI] being pressed, press [DEL] to move to the ' - ' direction which is the risky direction.
The feed rate of forced movement is always 0.5 min
-1
.
!
CAUTION
통상 이 강제이동은 하지 말아주십시오.
이 강제이동은 위험방향으로 이동시키므로 부득이하게 조작을 행할 경우에는 주변으로의 충돌, 위험이 없는 것을 확
인하고 나서 조작해주십시오.
Avoid using forced movement, unless necessary.
Forced movement in risky direction must be conducted after ensuring
that the movement is safe from collision or other dangers.
Содержание NeoCon Series
