Polaris RANGER CREW 900 2014, Руководство пользователя

Страница: 256 / 447

6
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
© Copyright Polaris Sales Inc.
6.7
OVERHEATING / DIAGNOSIS
During routine maintenance, or whenever PVT system overheating is evident, it’s important to check the inlet and
outlet ducting for obstructions. Obstructions to air flow through the ducts will significantly increase PVT system
operating temperatures. The vehicle should be operated in Low when plowing or pulling heavy loads, or if extended
low speed operation is anticipated.
CLUTCH DRIVE BELT & COVER RELATED ISSUES: DIAGNOSIS
POSSIBLE CAUSES SOLUTIONS / WHAT TO DO
Loading the vehicle into a tall trailer
when in high range. Shift transmission to Low during loading of the vehicle to prevent belt
burning.
Starting out going up a steep incline
from a stopped position. When starting out on an incline, use Low gear. Shift transmission to Low
during loading of the vehicle to prevent belt burning.
Driving at low RPM or low ground
speed (at approximately 3-7 MPH). Drive at higher speed or use Low. The use of Low is highly recommended
for cooler PVT operating temperatures and longer component life.
Insufficient engine warm-up when
exposed to low ambient temperatures.
Warm engine at least 5 min., then with transmission in neutral, advance
throttle to approx. 1/8 throttle in short bursts, 5 to 7 times. The belt will
become more flexible and prevent belt burning.
Slow and easy clutch engagement. Fast, effective use of the throttle for efficient engagement.
Stuck in mud or snow.
Shift the transmission to Low, carefully use quick, firm throttle application
and avoid excessive slipping of the PVT system.
WARNING: Excessive
throttle may cause loss of control and vehicle overturn.
Climbing over large objects from a
stopped position.
Shift the transmission to Low, carefully use quick, firm throttle application
and avoid excessive slipping of the PVT system.
WARNING: Excessive
throttle may cause loss of control and vehicle overturn.
Belt slippage from water or snow
ingestion into the PVT system.
Remove the PVT drain plug. Shift the transmission to neutral. Using the
throttle, vary the engine rpm from idle to full throttle. Repeat several times
as required. During this procedure, the throttle should not be held at the
full position for more than 10 seconds. Clutch seals should be inspected
for damage if repeated leaking occurs.
Clutch malfunction.
Clutch component inspection should be performed by a Polaris MSD
certified technician.
Poor engine performance.
Fouled spark plugs, foreign material in fuel tank, restricted fuel lines, or
faulty fuel pump may cause symptoms similar to clutching malfunction.
GENERAL RANGE OPERATION
GUIDELINES:
Low: Heavy pulling, basic operational speeds less than 7 MPH, riding
through rough terrain (swamps, mountains, ect.), low ground speeds.
High: High ground speeds, or speeds above 7 MPH.
Operating in Low Gear
Low gear should be used when riding through rough terrain or when basic operational ground speeds are less than 7
MPH. Use High gear when basic operational ground speeds are more than 7 MPH.
NOTE
Using High gear for heavy loads, hilly terrain, or in wet, muddy conditions will increase the chance of drive belt
burning.
CLUTCHING