Panasonic LP-RH Series, Руководство по установке и обслуживанию, Страница: 35 / 240

35
1. Laser radiation indicator
The display that shows the status of laser radiation and the laser marker.
Laser marker status Head LED status
Being in laser emitting Orange lighted-up
Laser pumping is completed and internal shutter opened Green lighted-up
Laser pumping is completed and internal shutter closed White lighted-up
Laser pumping is in progress (uncompleted) and internal shutter opened Green flashing
Laser pumping is in progress (uncompleted) and internal shutter closed White flashing
Laser in non-pumped state Lights-out
WARNING
• If the laser emission indicator is placed out of the sight of operators, place
the external indicator light or warning lamp on the immediately apparent
place on the system.
2. Signal connector: SIGNAL
This is the terminal for communicating between head and controller. Connect the attached signal cable.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• For the connecting details, refer to “2-6-1 Connection of head and controller” (P.59).
3. Power connector: POWER
This is the connector for supplying the power to the head.
Connect the attached unit power cable.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• For the connecting details, refer to “2-6-1 Connection of head and controller” (P.59).
4. Laser Pointer Emission Port
From this port the red laser pointer radiates in oblique direction when using the work distance indication of the guide
laser. Refer to “2-3-5 Marking position check” (P.50).
To use the guide laser, do not seal the laser pointer emission port at the installation.
5. Laser emission port
The emission port of the marking laser.
6. Focus Dial
This is the dial to check the focus adjusting. For the details, refer to “2-3-6 Focus adjustment function” (P.51).
7. Focus Adjusting Control
The control for adjusting the distance from the work. For the details, refer to “2-3-6 Focus adjustment function” (P.51).
8. Intake Vent for Air Cooling
Air inlet for cooling the head. In this vent the filter is installed.
9. Setscrew for Scanning Angle [Only for standard head]
This is the setscrew for rotation of head scanning. Loosen this setscrew for rotating scanner.
For the details, refer to “2-3-3 Rotation of Standard Head Scanner” (P.48).
ME-LPRH-SM-3