Panasonic LP-RH Series, Руководство по установке и обслуживанию, Страница: 122 / 240

122
„
With “allow to stop halfway” setting
When the trigger mode is set to “continuous trigger” in the file settings, lasing operation is repeated while TRIGGER IN (X5)
is on. With “allow to stop halfway” setting, the lasing operation is terminated immediately when TRIGGER IN turns OFF.
T2
T4
T3 T3
T6
T5
T2
T1
READY OUT (Y5)
TRIGGER IN (X5)
PROCESSING OUT
(Y10)
PROCESSING END
OUT (Y11)
PROCESSING FAIL
OUT (Y12)
ALARM OUT (Y15)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON (Normal)
OFF (Error)
ON
OFF
Marking
interruption
LASING OUT
(No.40)
Item Time Remarks
T1 2 ms or more Keep the ON status for the duration of repeating the lasing operation.
T2 0 to 9999 ms When the trigger delay time is set in the selected file, trigger processing (lasing) operation
starts after the delay time.
T3 0.0 to 60.0 sec. When the scanning interval is set, the next lasing operation starts after a lapse of the
setting period.
T4 2 to 510 ms This is the output to notify that the marking trigger processing completed normally. This
is One-shot output. Set the output time on the system settings screen. There is a small
margin of error for the setting value.
When the marking operation stops halfway because TRIGGER IN turns OFF, it is treated
as normal operation end.
T5 ― Time for marking data creation. It varies depending on the quantity of the setting data. This
time is required at every marking.
T6 2 to 510 ms If the trigger processing was stopped by an alarm or a warning, PROCESSING FAIL OUT
(Y12) turns on during the one-shot output period. PROCESSING END OUT (Y11) will not
be output at this time.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• If the executed number of lasing operation are less than the specified minimum number, warning E630 occurs after the
marking operation.
• If TRIGGER IN signal remains ON though the executed number of lasing operation reaches the specified maximum
number, warning E631 occurs and the subsequent lasing is canceled.
ME-LPRH-SM-3