Panasonic LP-RH Series, Руководство по установке и обслуживанию, Страница: 231 / 240

231
ERROR
CODE
Description Measures *1
E669
• Unable to generate bar code in the condition
specified.
• The number of bar code characters is
incorrect relative to the set conditions.
Check the code settings and the number of
characters.
E670
The dimensions of the narrow element or the
module width for the bar code are too small.
Specify the setting value for the narrow element or
the module width larger than that of the “line width
(calculation value)” specified in the object group
settings.
E671
The quiet zone is not configured correctly at the
bar code inversion mode settings.
Set the proper value for “Quiet/Narrow Ratio”.
E672
The settings for separator height ratio or row
height ratio are too small.
• Correct the separator height ratio or the bar code
height ratio so that the height is larger than the “line
width (calculation value)” specified in the object
group settings.
• If you want to remove the separator, set 0 to the
separator height ratio.
E673
Cannot create bar code due to the invalid
number of characters for EAN/UPC/JAN code or
GS1 DataBar.
Enter the prescribed number of characters according
to the code type.
E674 The string containing “%” is not properly set.
• If the functional characters such as a counter and
date/time are input, delete and re-enter characters
after “%”.
• To enter “%” as a character to mark, enter “%%”.
• To enter “+” or “/” as a character to mark after the
counter, enter “%+” or “%/”.
E678
The string No. specified by the SIN command is
not acceptable because the No. has not been set
in Laser Marker NAVI smart.
Specify the same No. set in “characters specified by
SIN command” setting in Laser Marker NAVI smart
to the string No. in SIN command data.
E679 *2, *3
Communication was interrupted. The adjustment
value of power optimization by marking position
could not apply to the laser marker.
• Set the adjustment value of power optimization by
marking position and apply it to the laser marker
again.
• Do not turn off the power during the application
processing.
• Do not turn on the remote mode during the
application processing.
E680
Any of the following functions that are not
available with the RUN mode ON are configured.
• Registered characters via I/O
• External offset (via I/O and SEO command)
• Characters specified by SIN command
• Link control with external image checkers
• To execute marking in the RUN mode, delete
these functions from the marking data.
• When you use these functions, control the laser
marker in the remote mode.
ME-LPRH-SM-3