Panasonic LP-RH Series, Руководство по установке и обслуживанию, Страница: 142 / 240

142
5-2-2 Communication settings (for command control)
Item RS-232C communication settings (for command control)
Synchro system Start-stop method
Communication type Full-duplex transmission
Baud rate 1200 / 2400 / 4800 / 9600 / 19200 / 38400 / 57600 / 115200 bps (initial setting: 9600 bps)
Data length 8-bit fixed
Parity None / Even / Odd (initial setting: None)
Stop bits 1-bit / 2-bit (initial setting: 1-bit)
Flow control None
Check sum OFF / ON (initial setting: OFF)
End code CR / CR + LF (initial setting: CR)
Start code * ON (STX) / OFF (initial setting: STX)
Response data command * ON / OFF (initial setting: ON)
Response data sub
command *
Any single byte character of ASCII code from 01 (HEX) to 7F (HEX) can be specified.
• Initial setting of positive response code: A
• Initial setting of negative response code: E
• Initial setting of read request response code: A
Character code ASCII code
Encoding for non-ASCII
characters *
Shift-JIS / GB 2312 / Latin-1 (initial setting: Shift-JIS)
Reception timer Timeout monitoring ON (10 sec.)
* If you select “LP-400/V compatible” for “Compatible mode” in the system settings of Laser Marker NAVI smart, the same
command format with the former models of LP-400/LP-V series is applied regardless these settings. For the details, refer
to the “Serial Communication Command Guide: LP-400/V compatible mode”.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• For the details of the communication settings, refer to “3-4-3 General settings before external control” (P.86).
• When using RS-232C, specify the “Flow control” to “None” at the communication port settings of the external control
device.
ME-LPRH-SM-3