Oriental motor EMP400 Series, Руководство по эксплуатации

Страница: 12 / 116

5 Installation
－
12
－
5.3 Installation method
Mount the controller on a DIN rail. In case the DIN rail produces significant vibrations, mount the
controller on an appropriate metal plate.
Mounting the controller on a DIN rail
Use a DIN rail of 35 mm (1.38 in.) in width. Use the end
plates to secure the controller mounted on the DIN rail.
1.
Engage the hook on the back of the controller over
the DIN rail by pulling down the controller’s DIN
lever, and push the controller until the DIN lever
locks in place.
2.
Secure each end of the controller using the end
plates.
Tab
DIN rail
DIN lever
Installing the controller with screws
Install the controller on a metal plate and secure it using
two screws (M3 or M4, two pcs.: not supplied).
There should be no gap between the controller and plate.
125
±0.1
mm
(4.92
±0.004
in.)
Removing the controller from the DIN rail
1.
Use a flat-head screwdriver to pull down the DIN
lever until it locks in place.
Pull the DIN lever with a force of 10 to 20 N (2.2 to
4.41 lb.).
Applying excessive force may damage the DIN lever.
2.
Raise the controller upward to remove from the
DIN rail.
DIN lever