Nidec LEROY-SOMER Powerdrive FX, Руководство по вводу в эксплуатацию

Страница: 39 / 176

39
QUICK SETUP MODE
Commissioning manual Powerdrive MD2/FX
4617 en - 2017.09 / e
Note 1 :
In the event the minimum switching frequency is not available, set the value according to the table below.
- For LSRPM motor, use the informations in the following table
Rated Speed Minimum Switching Frequency
≤ 1800 rpm 3 KHz
1800 rpm < Rated N ≤3600 rpm 4KHz
3600 rpm < Rated N ≤4500 rpm 5KHz
4500 rpm < Rated N ≤5500 rpm 6KHz
For LSRPM132 et 160 with a rated speed ≥ 2400 rpm, set 8 kHz
- For induction motor, keep the factory setting
A
yes
No
1 - Close STO1 and STO2 to enable the drive. HMI displays “Ready”
2- Give run command to start Autotune sequence. HMI displays « Autotune » during the sequence and reverts
to « Ready” once completed
3- Open Run command when sequence is completed
4 - Set
Ctr.14
(Autotune) = “Encoder offset measure”
5- Close STO1 and STO2 to enable the drive. HMI displays “Ready”
6 - Give run command to start Autotune sequence. HMI displays « Autotune » during the sequence and reverts
to “Ready” once completed
7 - Open Run command when sequence is completed
L’application est prête à fonctionner
Parameter settings are automatically memorized in drive control board. However it is possible to make a copy in
the HMI using procedure described in paragraph 2.2.3.3
Set Spd.09 (Speed loop proportional gain) and Spd.10 (speed loop intégral gain Ki1) to set the stability of the motor
speed with MDX-SOFT
Set the following parameter:
Spd.01
(Maximum Speed) (rpm)
Spd.06 (Acceleration rate) (s/1000rpm)
Spd.07
(Deceleration rate) (s/1000rpm)
Main operating parameters
Wish
to trip on
minimum speed
threshold
?
Minimum Speed trip settings
• Apl.08 (Minimum Speed Threshold) (rpm)
•
Apl.09
(User trip 1) Sets the drive to trip and
displays trip message
• Apl.10 (Masking time)(s).) Represents time
to reach minimum speed during
acceleration.
Run Autotune sequence