NEC ShieldPRO N22A, Руководство пользователя

Страница: 84 / 173

84
2.13.1 Installing/Removing HDD/Silicon Disks
Removal
1
Turn off the power of N22A if operated.
2
Unplug the power cord from the AC outlet and remove the AC adapter from N22A.
When using a car adapter, unplug it from the cigar lighter receptacle and then remove the
car adapter from the N22A.
3
Remove the battery pack from N22A.
See
“
Replacing Battery
”
in
“
Chapter 2 Uses of N22A
”
for the removal products.
4
Remove the anti-theft screws if they are to be used.
5
While pressing the button of the HDD/silicon disk cover on the right side, slide the
cover upward to open it.
6
Hold the HDD removal support and then pull out the HDD horizontally.
Installation
1
Insert a hard disk/silicon disk assembly into the disk storage area until it is securely
connected.
2
Close the cover, and then press down the part slid to the original position.
3
Attach the anti-theft screws if they are to be used.
4
Install a battery and connect an AC adapter or car adapter.
HDDs are extremely precise equipment. Note the following if used.

During data read/write (with the access lamp being ON), only a small shock may cause the
HDD to be defected.

If the HDD is defected, important data may be unavailable at a time and unable to be restored.
It is recommended to frequently back up important data for which the same data cannot be
created twice.

Depending on models of HDDs, a region with no drive number assigned appears in the [Disk
Management] dialog box. This is the re-setup region required for re-setup. Do not provide the
region with such processing as deletion from targets of disk management.
Put the cover so that the HDD removal support may not be caught.
The HDD/silicon disk cannot be inserted in the wrong direction (upside down). Carefully
check its direction.