NEC ShieldPRO N22A, Руководство пользователя

Страница: 61 / 173

61
U
se
s
o
f N
2
2
A
2.8.2 Battery Types
Batteries that can be used with the N22A are listed below. Be sure to use a battery of the
same type as the selection menu installation type for your N22A.
Battery type Description
Standard type
（
FC-BP01N
）
A lithium-ion battery provided with the FC-N22A (standard model and silicon disk
model)
Wide temperature range
type
（
FC-BP01N/W
）
A lithium-ion battery provided with the FC-N22A (HDD wide temperature range
model)
Stamina standard type
（
FC-BP01N/L
）
A lithium-ion battery provided with the FC-N22A (silicon disk/stamina standard
battery model)
2.8.3 Charging Battery
Charge the battery as shown below.

Connect the AC adapter to N22A and a power outlet

Connect the AC adapter to the battery charger (optional, FC-BC01N) and an outlet.

Connect the car adapter (optional, FC-VA01N) to the N22A and a cigar lighter receptacle.

Connect the car adapter (optional, FC-VA01N) to the battery charger (optional, FC-BC01N)
and a cigar lighter receptacle.
When battery charging starts, the battery LED glows orange to indicate that the battery is being
charged. It is recommended to turn off the power of N22A while the battery is charged.
After the battery is fully charged, the battery charge LED goes off.
It takes about four hours to charge the battery fully.
Battery indicator LED Battery status
Off Battery is not being charged or is fully charged.
Illuminating orange Battery is being charged.
Blinking orange (at 1 sec. intervals) Battery has stoped charging because of the ambient
temperature.
Blinking orange (at 0.5 sec. intervals) Battery error

The battery charge level varies according to the Battery Charge Mode selection in the BIOS
setting. (Normal : 100%, Longlife : 80%, Keeping : 50%, Auto(initial value) : 100% or 80%).
For details, see
“
Battery Charge Mode
”
of
“
Power Management Configuration
”
in
“
Chapter 4
Setting BIOS
”
.

Just after the battery is fully charged, do not take the procedure of removing the AC adapter
from N22A and reconnecting it to start charging again. Failure to follow this instruction may
cause the battery to be damaged.

If an error occurs in the battery, the battery charge LED blinks. The temperature may rise
extraordinary or the battery may be defected. Move N22A to a place of good ventilation or
stop using N22A to lower its temperature.
If the battery charge LED blinks still, remove the AC adapter from N22A and stop using it.
Contact your service representative.

The battery is not charged any more if its temperature exceeds the range of 5 to 50ºC.

When charging the battery, do not remove the AC adapter or car adapter until the battery is
fully charged. If the adapter is removed during charging, the battery will not be fully charged.