NEC ShieldPRO N22A, Руководство пользователя

Страница: 70 / 173

70
2.10.2 Protecting Data
Set the write protect switch on the SD card to the
“
LOCK
”
position. Move the switch to the
“
LOCK
”
position for new recording (checkout), editing or file storage.
NEC recommends you to back up important data to other media.
NEC assumes any responsibility for direct and indirect faults including loss of data saved by
customers.
NEC recommends that, if an SD card is disposed, it is destroyed physically by using such a tool
as a hammer to prevent personal data from being flown out.
2.10.3 Installing or Removing SD Card in/from SD Card Slot
Inserting SD Card into SD Card Slot
1
Open the cover on the right side of the N22A.
Slide the knob to the left to unlock the cover.
2
Insert a card from the side with cut corner, facing up the label surface.
Removing SD Card from SD Card Slot
1
Halt the SD card.
1. Double-click the [Safely Remove Hardware] icon on the task tray at the lower
right corner of the screen
2. In the [Safely Remove Hardware] window, click the name of the device to be
removed and then click [Stop].
3. When [Stop of Hardware Device] is displayed, click [OK].
4. Click [Close] to close the [Safely Remove Hardware] window.
The procedure is not required if the SD card is removed in the power-off state.
2
Pushing the SD card allows it to be popped up a little. Then pull out the card.
Before the SD card can be stored, it should be saved in a case.

When an SD card is inserted to the SD card slot, note the orientation of the card. Inserting
an SD card in invalid orientation may cause a fault to occur.

Do not insert/remove a card until the Windows login screen or desktop is displayed.
Wait for about 30 seconds after resuming from the suspend (standby) or hibernate status
before accessing the card.

Before the SD card can be removed, the card must always be halted.
Do not remove the SD card from the SD card slot in any of the following cases. Failure to
follow this instruction may cause important data to be damaged or the SD card to be
accessed improperly at the next installation.

N22A is in the suspend (standby) or pause state,

The SD card opens one or more files (first close the files before removing the SD
card),

The SD card reads of writes data from or to N22A, or

Just after the SD card performs operation such as writing

The SD card may access to N22A intermittently.