NEC ShieldPRO N22A, Руководство пользователя

Страница: 16 / 173

16

This product is a radio equipment that satisfies
“
Station of the small electric power data
communications system
”
defined in Article 6, Paragraph 4 of the radio law ministerial
ordinance in Japan. It also satisfies
“
Local telecommunication terminal equipment using
the radio wave
”
defined in Article 36 of ordinance for terminal equipment in Japan.
Disassembling and/or modifying this product offense these laws. Never attempt to
disassemble or modify the product.
In addition, this product can be used only in Japan.

The radio wave output of this product is lower than the reference value defined in
“
Radio
Frequency-Exposure Protection Standard (RCR STD-38)
”
by Association of Radio
Industries and Businesses.

In the use frequency band of this product, RFID Equipment for Premises Radio Station
(license required), Specified Low Power Radio Station (license not required), and Radio
Equipment for Personal Use (license required) are operated as well as industrial, scientific,
and medical equipment.
(1) Before using this product, make sure that the specific small-power wireless station or
amateur wireless station is not operating around you.
(2) If this product generates harmful radio interference to the local station for mobile object
identification, immediately change frequency bandwidth or stop emitting radio wave.
Then, consult with your service representative about measures to avoid radio
interference (e.g., installing a partition).
(3) If this product generates harmful radio interference to the specific small-power
wireless station or amateur wireless station, contact your service representative.

Stop emitting radio wave immediately if this product generates radio interference to the
local station for mobile object identification.

Federal Communications Commission (FCC) Notice
WARNING
Changes or modifications not expressly approved by the party
responsible for compliance could void the user
’
s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 ofthe FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance withthe instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help.
Properly shielded a grounded cables and connectors must be used for connection to host
computer and / or peripherals in order to meet FCC emission limits.

USA:Federal Communications Commission(FCC)
This device complies with Part 15 of the FCC Rules. Operation of the device is subject to the
following two conditions:

This device may not cause harmful interference.