F-10 PREPARATION BEFORE STARTING MASS PRODUCTION
19)
Press the
(ST) switch.
1.
Because the machine lock function is valid, the axes do not move even if the
program is executed. Only the position data on the screen is updated.
2.
When the single block function is valid, program execution stops after each program
block. To advance to the next block, press the
(ST) switch again.
The single block function is used to check the following
Tool mounting order
Spindle speed
3.
If the coolant OFF mode is currently valid, coolant will not be supplied even if an M08
(coolant ON) command in the program is carried out.
WARNING
Before switching the machine lock function from "valid" to "invalid", wait
until one program operation cycle has been completed. After switching
from "valid" to "invalid", always execute a zero return operation.
Switching between "valid" and "invalid" during program execution will
create a discrepancy between the position designated in the program and
the actual machine position, which could cause accidents involving
serious injuries or damage to the machine.
CYCLE
ST
SP
NOTE