Moog DS2110, Инструкция по установке и эксплуатации

Страница: 44 / 312

CHAPTER 3.0 Wiring and Installation 3-6
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
Figure 3.2 Typical DS2110 Cable Bend Radius Requirements
The DS2110 must be permanently and reliably connected to Earth and all conductive parts in the IP54 rated
enclosure or cabinet must be permanently connected to Earth. The impedance between the earth terminal and
any accessible part of the enclosure or cabinet should be less than or equal to 0.1 ohm.
NOTE - The DS2110 Series Servo-drives are system components that must be
installed in the correct manner to ensure that all electromagnetic compatibility (EMC)
requirements are met. (Refer to Chapter 2 of this User’s Guide).
The DS2110 must be mounted on a panel with a flat solid surface in a manner that
ensures that EMC earthing requirements are met.
There must be a clean flat conductive surface at all of the mounting points. Remove
paint or other insulating materials and provide conductive corrosion protection at the
mounting points. It is important that there is good high-frequency bonding between the
panel and the DS2110 Servo-drive. Conductive hex socket head bolts with conductive
locking washers should be used.
Required for
CE-Compliance