Moog DS2110, Инструкция по установке и эксплуатации

Страница: 31 / 312

CHAPTER 2.0 Safety & EMC Instructions 2-16
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
Motor power cables MUST be shielded with the cable shield securely connected to Chassis Earth at both ends of
the cable. At the DS2110 end of the cable, the shield shall be earthed to Chassis Earth using the EMC kit or the
panel earth bar. The correct method to earth the shield is shown in Figure 2 Correct Cable Preparation Grounding
of Shield to Chassis.
Figure 2 - Correct Cable Preparation Grounding of Shield to Chassis
Motor resolver/signal cables must be shielded with the cable shield securely connected to Chassis Earth at both
ends of the cable.
Signal cables must be shielded with the cable shield securely connected to make a good HF earth bond to
Chassis Earth at both ends of the cable.
Typical cable shield terminations for each of the cables on each DS2110 size are shown in the following figures.