Moog DS2110, Инструкция по установке и эксплуатации

Страница: 103 / 312

CHAPTER 4.0 Getting Started 4-1
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
4.1 Introduction
The getting started guide will provide you with the information needed to get a DS2110 configured and
operational. The guide will show the typical steps required to operate a DS2110 controller using the Windrive
Software.
Before starting this section, the user should become familiar with Sections 1 - Sections 3 of this manual, in
particular safety notices and hazard warnings.
After completing this guide, the user will be able to perform basic motor operations using a DS2110 in both
Torque and Velocity Mode.
Note: The example in this chapter demonstrates how to set up and configure a motor with resolver
feedback.
4.2 Initial Preparation
Install the drive as per Section 3 with regards to the safety notices indicated in section 2. As a minimum the
following items are required before getting started:
ƒ
A DS2110 Controller.
ƒ
A PC Running Windows 98, Windows ME, Windows NT 4.0 (Service Pack 6 or later), Windows 2000,
Windows XP with at least one RS232 serial port
ƒ
24Vd.c and/or 230V/400Va.c
ƒ
Motor with resolver feedback
ƒ
Drive Enable Input
4.3 Power Supply
The DS2110 requires a control power source to supply backup-power for the control electronics. This control-
backup power is useful where the user requires that the DS2110 does not lose absolute position data or status
information when AC mains power is removed from the DS2110.
For the G362-x003 &-x006 a 24V
dc
logic backup supply is mandatory for the drive to operate. No internal high
voltage backup is provided on the smaller µA models.