Mitsubishi Electric MR-JE-_A, Инструкция по эксплуатации

Страница: 67 / 370

3. SIGNALS AND WIRING
3 - 32
3.6 Detailed explanation of signals
3.6.1 Position control mode
POINT
Adjust the logic of a positioning module and command pulse as follows.
MELSEC iQ-R series/MELSEC-Q series/MELSEC-L series positioning
module
Signal type
Command pulse logic setting
Positioning module
Pr. 23 setting
MR-JE-_A servo amplifier
[Pr. PA13] setting
Open-collector type
Positive logic Positive logic (_ _ 0 _)
Negative logic Negative logic (_ _ 1 _)
Differential line driver type
Positive logic (Note) Negative logic (_ _ 1 _)
Negative logic (Note) Positive logic (_ _ 0 _)
Note. For MELSEC iQ-R series/MELSEC-Q series/MELSEC-L series, the logic means N-side
waveform. Therefore, reverse the input pulse logic of the servo amplifier.
MELSEC-F series positioning module
Signal type
Command pulse logic setting
Positioning module (fixed)
MR-JE-_A servo amplifier
[Pr. PA13] setting
Open-collector type
Differential line driver type
Negative logic Negative logic (_ _ 1 _)
(1) Pulse train input
(a) Input pulse waveform selection
You can input command pulses in any of three different forms, and can choose positive or negative
logic. Set the command pulse train form in [Pr. PA13]. Refer to section 5.2.1 for details.
(b) Connection and waveform
1) Open-collector type
Connect as follows.
Approximately
1.2 k
Ω
Approximately
1.2 k
Ω
SD
Servo amplifier
OPC
PP
NP
DOCOM
24 V DC
(Note)
Approximately
1.2 k
Ω
Servo amplifier
PP2
PG
V
CES
≤
1.0 V
I
CEO
≤
100
μ
A
(Note)
(Note)
Approximately
20 mA
Approximately
20 mA
Approximately
1.2 k
Ω
NP2
SD
NG
V
CES
≤
1.0 V
I
CEO
≤
100
μ
A
24 V DC ± 10%
300 mA
For sink input interface For source input interface
Note. Pulse train input interface is comprised of a photocoupler.
If a resistor is connected to the pulse train signal line, it may malfunction due to reduction in current.