Mitsubishi Electric MR-JE-_A, Инструкция по эксплуатации

Страница: 343 / 370

APPENDIX
App. - 4
(3) USA/Canada compliance
This servo amplifier is designed in compliance with UL 508C and CSA C22.2 No. 14.
(a) Installation
The minimum cabinet size is 150% of MR-JE servo amplifier's volume. Also, design the cabinet so
that the ambient temperature in the cabinet is 55 °C or less. The servo amplifier must be installed in
the metal cabinet. Additionally, mount the servo amplifier on a cabinet that the protective earth based
on the standard of IEC/EN 60204-1 is correctly connected. For environment, the units should be
used in open type (UL 50) and overvoltage category shown in table in app. 3.7.1. The servo amplifier
needs to be installed at or below pollution degree 2. For connection, use copper wires.
(b) Short-circuit current rating (SCCR)
Suitable For Use On A Circuit Capable Of Delivering Not More Than 100 kA rms Symmetrical
Amperes, 500 Volts Maximum. For SCCR when using a Type E Combination motor controller, refer
to section 11.6.
(c) Overload protection characteristics
The MR-JE servo amplifiers have solid-state servo motor overload protection. (It is set on the basis
(full load current) of 120% rated current of the servo amplifier.)
(d) Over-temperature protection for motor
Motor Over temperature sensing is not provided by the drive.
Integral thermal protection(s) is necessary for motor and refer to app. 3.3 for the proper connection.
(e) Branch circuit protection
For installation in United States, branch circuit protection must be provided, in accordance with the
National Electrical Code and any applicable local codes.
For installation in Canada, branch circuit protection must be provided, in accordance with the
Canada Electrical Code and any applicable provincial codes.
(4) South Korea compliance
This product complies with the Radio Wave Law (KC mark). Please note the following to use the
product.
이 기기는 업무용
(A
급
)
전자파적합기기로서 판매자 또는 사용자는 이 점을 주의하시기 바라며
,
가정외의
지역에서 사용하는 것을 목적으로 합니다
.
(The product is for business use (Class A) and meets the electromagnetic compatibility requirements.
The seller and the user must note the above point, and use the product in a place except for home.)
App. 2.1.4 General cautions for safety protection and protective measures
Observe the following items to ensure proper use of the MR-JE servo amplifiers.
(1) For installing systems, only qualified personnel and professional engineers should perform.
(2) When mounting, installing, and using the MR-JE servo amplifier, always observe standards and
directives applicable in the country.
App. 2.1.5 Disposal
Disposal of unusable or irreparable devices should always occur in accordance with the applicable country-
specific waste disposal regulations. (Example: European Waste 16 02 14)