Mitsubishi Electric Melservo MR-J3- 350B4, Инструкция по эксплуатации

Страница: 134 / 408

5 - 17
5. PARAMETERS
5.3 Extension setting parameters (No. PC )
POINT
Parameter whose symbol is preceded by * is made valid with the following
conditions.
* : Set the parameter value, switch power off once after setting, and then
switch it on again, or perform the controller reset.
**: Set the parameter value, switch power off once, and then switch it on
again.
5.3.1 Parameter list
No. Symbol Name Initial Value Unit
PC01 ERZ Error excessive alarm level 3 rev
PC02 MBR Electromagnetic brake sequence output 0 ms
PC03 *ENRS Encoder output pulses selection 0000h
PC04 **COP1 Function selection C-1 0000h
PC05 **COP2 Function selection C-2 0000h
PC06 *COP3 Function selection C-3 0000h
PC07 ZSP Zero speed 50 r/min
PC08 For manufacturer setting 0
PC09 MOD1 Analog monitor 1 output 0000h
PC10 MOD2 Analog monitor 2 output 0001h
PC11 MO1 Analog monitor 1 offset 0 mV
PC12 MO2 Analog monitor 2 offset 0 mV
PC13 MOSDL Analog monitor feedback position output standard data Low 0 pulse
PC14 MOSDH Analog monitor feedback position output standard data High 0 10000
pulse
PC15
For manufacturer setting
0
PC16 0000h
PC17 **COP4 Function selection C-4 0000h
PC18
For manufacturer setting
0000h
PC19 0000h
PC20 0000h
PC21 *BPS Alarm history clear 0000h
PC22
For manufacturer setting
0000h
PC23 0000h
PC24 0000h
PC25 0000h
PC26 0000h
PC27 0000h
PC28 0000h
PC29 0000h
PC30 0000h
PC31 0000h
PC32 0000h