Mitsubishi Electric Melservo MR-J3- 350B4, Инструкция по эксплуатации

Страница: 38 / 408

1 - 17
1. FUNCTIONS AND CONFIGURATION
(7) MR-J3-11KB(4) to MR-J3-22KB(4)
POINT
The servo amplifier is shown without the front cover. For removal of the front
cover, refer to section 1.7.2.
7 9
6
8
5
4
3
2 1
0
F
E
D
C
B
A
1 2
ON 4F SW1
SW2
TEST
Cooling fan Fixed part
(4 places)
Used to set the axis No. of servo amplifier.
Rotary axis setting switch (SW1)
SW2
Test operation select switch (SW2-1)
Used to perform the test operation
mode by using MR Configurator.
Spare (Be sure to set to the "Down"
position).
Detailed
Explanation
Section 3.13
Section 3.2
Section 3.4
SW1
Section 3.13
Name/Application
1 2
Display
The 3-digit, seven-segment LED shows the servo
status and alarm number.
USB communication connector (CN5)
Connect the personal computer.
I/O signal connector (CN3)
Used to connect digital I/O signals.
More over an analog monitor is output.
SSCNET cable connector (CN1A)
Used to connect the servo system controller or the front
axis servo amplifier.
SSCNET cable connector (CN1B)
Used to connect the rear axis servo amplifier. For the final
axis, puts a cap.
Encoder connector (CN2)
Used to connect the servo motor encoder.
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Battery connector (CN4)
Used to connect the battery for absolute position data
backup.
Rating plate
7
6
5
4
3
2 1 0 F
E
D
C
B
A
9
8
Chapter 4
Section 11.8
Section 3.2
Section 3.4
Section 3.2
Section 3.4
Section 3.4
Section 11.1
Section 11.9
Chapter 12
Section 1.5
Section 3.1
Section 3.3
Battery holder
Contains the battery for absolute position data backup.
Section 12.3
Main circuit terminal block control circuit protective
earth (TE)
Used to connect the input power supply, servo motor,
regenerative option and ground.