Mitsubishi Electric Melservo MR-J3- 350B4, Инструкция по эксплуатации

Страница: 334 / 408

13 - 37
13. SERVO AMPLIFIERS WITH A LARGE CAPACITY (30k TO 55kW)
13.3.7 Timing chart
(1) Power circuit timing chart
Power-on procedure
(a) Always wire the power supply as shown in above section 13.3.2 using the magnetic contactor with the
main circuit power supply (3-phase: L
1
, L
2
, L
3
). Configure up an external sequence to switch off the
magnetic contactor as soon as an alarm occurs.
(b) Switch on the control circuit power supply L
11
, L
21
simultaneously with the main circuit power supply or
before switching on the main circuit power supply. If the main circuit power supply is not on, the display
shows the corresponding warning. However, by switching on the main circuit power supply, the warning
disappears and the drive unit will operate properly.
1) When control function of magnetic contactor is enabled and the status remains at ready on
The main circuit power is not shut off with servo off.
ON
OFF
Main circuit
power supply
ON
OFF
Base circuit
ON
OFF
Servo-on command
(from controller)
(3s)
95ms 10ms
ON
OFF
Converter unit control
power supply
ON
OFF
Drive unit control
power supply
2) When control function of magnetic contactor is enabled and the status returns to ready off
The magnetic contactor of the converter unit is turned off with servo off, and the main circuit magnetic
contactor is shut off.
(3s)
95ms 10ms
ON
OFF
Main circuit
power supply
ON
OFF
Base circuit
ON
OFF
Servo-on command
(from controller)
ON
OFF
Converter unit control
power supply
ON
OFF
Drive unit control
power supply