Mitsubishi Electric Melservo MR-J3- 350B4, Инструкция по эксплуатации

Страница: 309 / 408

13 - 12
13. SERVO AMPLIFIERS WITH A LARGE CAPACITY (30k TO 55kW)
(3) Drive unit (MR-J3-DU30KB MR-J3-DU37KB MR-J3-DU45KB4 MR-J3-DU55KB4)
POINT
This servo amplifier is shown without the front cover. For removal of the front
cover, refer to section 13.1.7.
7
9
6
8
5
4
3
2 1
0
F
E
D
C
B
A
1 2
ON 4F SW1
SW2
TEST
fixed part
(4 places)
Cooling fan
Chapter 4
Section 3.2
Section 3.4
Section 11.8
Section 3.13
Section 13.1.4
Section 3.4
Section 11.1
Section 11.9
Chapter 12
Section 3.2
Section 3.4
Section 12.3
Rating plate
Section 13.3.1
SW2
SW1
8
7
6
5
4
3
2
1
0
F
E
D
C
B
A
9
1 2
Section 13.3.2
Motor power supply terminals (TE1)
Connect to U, V, W of the servo motor.
Display
The 3-digit, seven-segment LED shows the servo
status and alarm number.
Used to set the axis No. of drive unit.
Rotary axis setting switch (SW1)
USB communication connector (CN5)
Connect with the personal computer.
Battery holder
Contains the battery for absolute position data backup.
Encoder connector (CN2)
Used to connect the servo motor encoder.
SSCNET cable connector (CN1B)
Used to connect the rear axis drive unit. For the final axis,
puts a cap.
I/O signal connector (CN3)
Used to connect digital I/O signals.
More over an analog monitor is output
SSCNET cable connector (CN1A)
Used to connect the servo system controller or the front
axis drive unit.
Converter unit connectors (CN40A)
Connect to CN40 of the converter unit.
Battery connector (CN4)
Used to connect the battery for absolute position data
Converter unit connectors (CN40B)
Connect the termination connector (MR-J3-TM).
Name/Application
Detailed
Explanation
TE2-2
For manufacturer adjustment. Leave this open.
Control circuit terminal L
11
L
21
(TE3)
Supply control circuit power.
L L terminals (TE2)
Connect to the L L terminals of the converter unit
using the connection conductors supplied.
Test operation select switch (SW2-1)
Used to perform the test operation mode
by using MR Configurator.
Spare (Be sure to set to the "Down"
position).
Protective earth (PE) terminal ( )
Ground terminal.