Lenovo x3650 M4 BD 5466, Инструкция по установке и обслуживанию

Страница: 79 / 1222

Connector
Battery 2 / flash power module 2
Battery 1 / flash power module 1
Figure 52. RAID adapter battery installation
Note: The positioning of the remote battery depends on the type of the remote batteries
that you install.
b. Connect the other end of the battery cable to the battery cable connector on the battery.
c. Place the battery retention clip underneath while pressing the release tab toward the front of
the server until it snaps in place to hold the battery retention clip firmly in place.
Note: The battery must recharge for at least 6 hours under normal operating conditions. To protect
your data, the ServeRAID controller firmware changes the write policy to write-through until the
battery unit is sufficiently charged. When the battery unit is charged, the ServeRAID controller
firmware changes the write policy to write-back.
If you have other devices to install or remove, do so now. Otherwise, go to “Completing the installation” on
page 136.
Installing the dual-port network adapter
Use this information to install the dual-port network adapter.
You can purchase one of the following dual-port network adapters to add two additional network ports in the
server. To order a dual-port network adapter option, contact your sales representative or reseller.
Chapter 2
.
Installing optional devices
67