Lenovo x3650 M4 BD 5466, Инструкция по установке и обслуживанию

Страница: 55 / 1222

Installing a simple-swap hard disk drive
Use this information to install a simple-swap hard disk drive.
You must turn off the server before installing simple-swap drives in the server. Before you install a
simple-swap SATA hard disk drive, read the following information. For a list of supported hard disk drives,
see http://www.lenovo.com/ serverproven/.
• Locate the documentation that comes with the hard disk drive and follow those instructions in addition to
the instructions in this chapter.
• Make sure that you have all the cables and other equipment that are specified in the documentation that
comes with the drive.
• Select the bay in which you want to install the drive.
• Check the instructions that come with the drive to determine whether you have to set any switches or
jumpers on the drive. If you are installing a SATA device, be sure to set the SATA ID for that device.
• You can install up to six 3.5-inch simple-swap SATA hard disk drives in the server. Do not install hot-swap
drives into a simple-swap server model, it is not supported.
• The simple-swap server models are available only in non-RAID configurations.
• The electromagnetic interference (EMI) integrity and cooling of the server are protected by having all bays
and PCI and PCI Express slots covered or occupied. When you install a drive, PCI, or PCI Express
adapter, save the EMC shield and filler panel from the bay or PCI or PCI Express adapter slot cover in the
event that you later remove the device.
• Before you install an additional simple-swap hard disk drive, go to Table 2 “Power supply configurations”
on page 9 for detailed power supply configurations.
To install a simple-swap hard disk drive, complete the following steps:
Step 1. Read the safety information that begins on “Safety” on page v and “Installation guidelines”
on page 34.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables.
Step 3. Remove the filler panel from the empty drive bay.
Step 4. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
Step 5. Install the hard disk drive in the drive bay:
a. Grasp the black drive handle and slide the blue release latch to the right and align the drive
assembly with the guide rails in the bay.
b. Gently push the drive into the bay until the drive stops.
Chapter 2
.
Installing optional devices
43